捕鱼大作战

Product introduction of electric heating melting furnace
The main performance specification of electric heating crucible melting furnace is used for melting or smelting of non-ferrous metals and alloys (aluminum, zinc, tin, lead) and Babbitt alloy with low melting point. Power: 20, 60, 75kw Temperature: 800 degrees Celsius; The shell of the furnace body is welded by section steel and steel plate, and the inner lining is built with ultra-light high-aluminum foam brick. Or vermiculite powder) bulk material structure to improve the insulation performance of the furnace body. There is a hole cover at the lower part of the front end of the electric furnace for frequent removal of dust below the furnace. When the bottom of the crucible is oxidized or cracked, or the liquid leaks, the solution at the crucible can flow out of the furnace through this hole so that The heating element and working room are not damaged. Outflow holes are usually filled with horse dung paper, avoid explosives. Prevent the cold air from outside the furnace from intruding into the furnace and affect the heating. A protective cover is installed at the rear end of the electric furnace, and the heating element wiring device is inside the cover. The furnace panel is equipped with two semi-circular furnace covers, and a thermocouple measuring hole is left after the furnace covers are combined and covered. The heating element is placed on the wire brick, and the socket brick is positioned. The crucible is cast from heat-resistant steel.

Previous: Crucible melting furnace

Next: Centralized melting furnace

Keywords: electric heating melting furnace

QQ Online Consulting
Online consultation
在线咨询