Main performance specifications of QR series inclined melting resistance furnace
Uses: For low melting non-ferrous metals and alloys (aluminum, magnesium, zinc, tin, lead) and Babbitt alloys, melting or smelting. Power: 12, 60, 75kw Temperature: 800 degrees Celsius. The furnace shell is welded by profile steel and steel plates, and the interior is made of ultra-light high-aluminum foam bricks to form the furnace lining. The insulation layer is made of aluminum silicate refractory fiber and diatomite (or vermiculite powder) bulk material to improve the furnace Thermal insulation performance. There is a hole cover at the lower part of the front end of the electric furnace for frequent removal of dust below the furnace. When the bottom of the crucible is oxidized or cracked or the liquid leaks, the solution at the crucible can flow out of the furnace through this hole to make the The heating element and working room are not damaged. Outflow holes are usually stuffed with horse dung paper. Avoid explosives. Prevent the cold air from outside the furnace from intruding into the furnace and affect the heating. A protective cover is installed at the rear end of the electric furnace, and the heating element wiring device is inside the cover. Through the worm gear reducer, the furnace body installed on the furnace frame can be tilted and cast within 90 degrees. The furnace panel is equipped with two semi-circular furnace covers, and a thermocouple measuring hole is left after the furnace covers are combined and covered. The heating element is placed on the wire brick, and the socket brick is positioned.